Try a stylize look below, or open your own picture.
Image on fire effect
Open a photo and apply Image on Fire in PictorX. This look is part of Stylize effects—adjust the settings on this page, then keep editing with layers, text, and other effects in the same workspace. Try a stylize look below, or open your own picture.
How it works
- Open this page and try Image on Fire on the sample, or open your own photo.
- Tune the Image on Fire settings, or switch to another look in Stylize effects.
- Save the result, or keep editing with layers, text, and other effects in PictorX.
What the Image on Fire effect does
Image on Fire is one of the looks in PictorX Stylize effects. Apply it in your browser, then keep working in the same project—crop, type, or add another effect without starting over.
More looks in Stylize effects
This page opens Stylize effects with Image on Fire already selected. Switch looks on the demo to compare styles, or open the full Stylize effects page to browse every option in the set.
Looks in this set
Frequently asked questions
What does the image on fire effect do?
It turns the photo into flames. Edges are streaked upward like rising fire, the result is softened and twisted into small swirls, and every pixel is then recolored on a fire scale: dark areas become black and deep red, mid tones red and orange, and bright areas yellow and white.
How do I set a photo on fire online?
Open your photo on this page; Image on Fire is already selected. Click Properties and set Strength (0 to 200), which controls how far the flames rise from the edges. Then click Save as image.
Which Strength should I use?
At 0 there are no flame streaks, only the fire colors and swirls. Around 20 to 60 gives short flames while the subject stays recognizable; 100 to 200 gives long flames that dissolve the image. Strength is measured in pixels, so on a large photo you need a higher value for the same look.
Which photos work best with the fire effect?
Photos with a clear shape against a dark background: a face, a hand, a car, text or a logo. Because the original colors are replaced by the fire scale, only brightness matters: the brightest parts become the hottest, white and yellow areas.
Can I keep the original colors and only add flames?
Not with the effect alone, because it always recolors the whole image. Click Edit, apply Image on Fire to a duplicate layer and set its blend mode to Screen, so the flames brighten the original photo below.
Ready to try it?
Open PictorX in your browser — no install, no credit card required to start.
Go to Editor